Support is only for the software, no advice or recommendation will be given on the use of maps. Except the brief descriptions available on the site, no additional information will be provided on the maps, any additional questions, please address in the appropriate forums.

Extra accessories required for Aprilia:

 

Cable:

To connect TuneECU with the Aprilia ECU a custom-built adaptor cable is required 
Pin assignment Fig.1, Fig.5 and Fig.6

To make up such a cable,the following components are required: (i) a diagnostic OBDII cable
with a 16-pin socket on the one side and flying  leads on the other (Fig. 2). This cable is commercially
available as an accessory in many OBD-motorsport shops (ii) a 6-pin connector  (Fig.3).


***Fig.1***


***Fig.6***

Thanks "moto-abruzzo" from the Aprilia-Forum


***Fig.2***

Typical application for the sample connector in Fig.3:

Aprilia ECU Male connector

Company Tyco Electronics / USA. Website click here
Housing: Manufacturer Part No: 770090-1 - Newark.com Part No: 50F2670
Connector: Manufacturer Part No:770145-1 - Newark.com Part No: 16H5735

Company Farnell Electronics / UK,  Website click here
6W 0.093" plug housing (Molex part number 03-09-2061) - Farnell order code 143-209
Order Code: 143209
Manufacturer: Molex
Manufacturer Part No: 03-09-2061
Crimp pins (Molex part number 02-09-2118) - Farnell order code 977-3800
Order Code: 9773800
Manufacturer: Molex
Manufacturer Part No: 02-09-2118


***Fig.3***

Fig.4


***Fig.5***

Who has disconnections when running engine, which can possibly help the Tip of "moto-abruzzo" from the Aprilia forum.  Link the cable shield with the ground pin of the OBD connector.
See the following picture.

Thanks "moto-abruzzo" from the Aprilia-Forum

All provided information on the sides of TuneECU have been made ​​in good faith,
but make no claim to completeness and correctness.

*** END ***